Skip to content
Wolfe Electric Company, residential and commercial
Close view of a charging plug in an electric car

Services

Electrical work for South Bay houses.

Repairs, panels, charger circuits, lighting, and the dedicated breakers kitchens and offices actually need. Based in Campbell. Serving San Jose, Sunnyvale, Cupertino, Los Gatos, Saratoga, and Santa Clara.

Outlet tester plugged into a duplex receptacle
Photo: Andrew Buck, CC BY-SA 4.0

01

Troubleshooting and repairs

A breaker that will not stay on, a room that went dark, a receptacle that smells warm, a GFCI that trips and will not reset. Jason finds the fault, tells you what it will take, and does the repair if you want it the same visit.

Small household jobs are the ones neighbors already describe on Yelp: kitchen outlets, a burnt connection, a new box on the back of the house. If the fault is in the wiring inside a wall, you hear that before any drywall comes off.

02

Panels and service changes

A lot of 1960s and 1970s houses in this valley still have 100-amp services. They run out of spaces, they run out of capacity, or both. A Level 2 charger, a heat pump, or a kitchen rebuild is often the moment the panel has to grow.

A 100-amp to 200-amp change needs a city permit and a PG&E disconnect and reconnect. On-site work is often one day. The wait is the permit and the utility window, commonly one to three weeks after the estimate, longer if the mast or the underground lateral is in bad shape.

Cupertino timing · Campbell ranches

Older house load center with a main breaker and labeled branch breakers
Photo: Circacies, CC BY-SA 4.0
Charging connector plugged into an electric car

03

EV charger circuits

A Level 2 charger is a continuous load. The breaker and the wire are sized at 125 percent of the charger nameplate. A 40-amp charger typically wants a 50-amp breaker. None of that matters if the load calculation says the existing service is already full.

The visit covers the panel, the path from the panel to the garage or driveway, and whether the wall can hold the unit. If the panel has to be upgraded first, that is a separate number, not a footnote. Eichler and radiant-ceiling houses in Sunnyvale get extra attention on that visit. Read the Sunnyvale page.

04

Outlets, switches, dedicated circuits

New receptacles, replacement of two-prong outlets, a circuit for a microwave, a dryer, a sauna, or a garage tool. Dedicated circuits are the clean fix when one breaker feeds too many rooms.

Older Willow Glen and Rose Garden houses often need a real ground, or a GFCI with the right label, before a new device is honest. See electrician in San Jose.

GFCI receptacle with test and reset buttons
Photo: Ben Kurtovic, CC BY-SA 4.0
Ceiling light fixture on a wood-trimmed ceiling
Photo: w_lemay, CC BY-SA 2.0

05

Lighting

Recessed lights where the attic is open, fixture swaps, dimmers that match the lamps, and exterior lights on a switch you can actually find. Attic access changes the price more than the fixture does. If the ceiling is closed, you hear that on the estimate.

Hillside lots in Los Gatos and Saratoga often add path lights and gate operators on long runs. Those jobs are priced for voltage drop, not just for the fixture count. Saratoga feeders.

06

Safety devices that belong with the repair

GFCI protection in kitchens, baths, garages, and outdoors. AFCI protection where the code requires it on a new circuit. Smoke and carbon monoxide alarms when a permitted job calls for them. Whole-home surge protection on a panel change, if you want it. These are part of doing the work to current code, which is what the inspector will look for.

What South Bay jobs cost

Ranges homeowners see. Your number comes from the visit.

These are 2026 ranges people in Santa Clara County commonly pay. They are a planning guide. The written price comes after Jason sees the panel, the wire path, and whether the city and PG&E are involved.

Tell us the city and the job.

Campbell, San Jose, Sunnyvale, Cupertino, Los Gatos, Saratoga, or Santa Clara. The estimate visit is free.